Plumbing Emergency

Need To Tackle A Plumbing Emergency? Check Out These Tips First!

Did you know that a leaky spray head on your kitchen sink might be caused by a faulty diverter? If this peaks your interest or if you want to know more about plumbing, then you will want to read what else we have to provide in this article about how to take care of plumbing in your home.

Plumbing Emergency

Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

As the weather begins to get cold, attend to all of your exposed pipes by adding insulation to them. Pay particular attention to pipes located in crawl spaces and the outside walls of your residence. Taking this step will help ensure that your pipes continue to function throughout the winter.

Make sure everyone that lives in your house knows where to find and use the main water shut off valve in case there is a burst pipe emergency. This is especially important if you live in an area where your pipes may freeze. Take a moment to show your family members where the valve is and how to properly shut it off.

Do not use harsh chemicals to clean or treat your toilet. While they may be effective deodorizers, they can damage rubber parts in your toilet. If they become too damaged, your toilet will not operate properly.

Good management and prevention can help you save money on plumbing. Clogged drains are one of the more common issues when it comes to plumbing problems. Clogs in drains are often caused by buildups of hair. Stop the clog by covering your drains with screens to keep hair from going into the pipes. Taking the hair off of the screen and disposing of it is cheaper and easier than removing it from the pipes.

Do not forget to check the temperature of the water heater in your house, especially if you are planning to leave for an extended period of time. You should keep the temperature no higher than 120 degrees, which will help to reduce energy use and prevent your system from burning out.

Frozen pipes can lead to many problems, most of them expensive to fix. So you want to avoid that at all costs. To avoid frozen pipes, make sure the temperature in your home never drops below 55 degrees. Look for any air leaks around your pipes and make sure they’re sealed up.

If you have a crack in your toilet tank, you can sometimes fix this with an epoxy resin. However, it is very difficult to keep up with this type of maintenance, and the best bet may be contacting the supplier and ordering a new tank to be installed in your bathroom. Nevertheless, keeping some epoxy resin on hand for emergencies is a good idea.

In conclusion, that leaky faucet may just be easier to fix than you imagined. Instead of making a call to a plumber, having to wait, and then paying out top dollar, you can now fix it yourself. Use this advice to put yourself in the best financial situation possible when it comes to plumbing.

Leave a Reply